RAK HR

RAK HR



Rotor RAK HR works with controller Rot1Prog. It it can be used for lightweight construction, such as Yagi and heavy shortwave antennas. It is based on the worm gear, worm and worm wheel made of steel (as pictured). These features ensure long life and durability of the device. Its advantage is the possibility to adjust the worm and worm wheel clamping, clearing backlash in the drive mechanism, which may be necessary in the case of wear and tear after long-term use. The device surface is covered with powder coating, effectively protecting against corrosion. Range trading is protected by limit switches.

Specification

Parameter Value
Rotating Torque: 1800
Rotating Torque – 24V: 3240
Braking Torque: 14000
Vertical load: 550lbs
Break type: Double worm
Carter: Metal
Gear: Metal
Mast plate: Metal
Reduction ratio: 4950 / 1
Endocer type: Magnetic 32 pulse
Precision: 0.1° / 0.1°
Rotation angle: 360° +/- 180°
Rotation time for 360°: 90 sec.
Rotation time for 360° – 24V: 45 sec.
Electric motor: 12 Vdc
Enviornment: -20° / +50°
Weight antenna rotor: 12 Kg

Controllers

MD-01
01 MD-01 is an electronic driver used for turning rotors. It is a multifunctional device, allowing for various combinations of work setting. The driver may be connected to two single rotors (e.g. two Azimuth rotors) or double (one Azimuth / Elevation rotor). The basic circuit provides operation with direct current motors.
MD-02
01 MD-02 is an electronic driver used for turning rotors. It is a multifunctional device, allowing for various combinations of work setting. The driver may be connected to two single rotors (e.g. two Azimuth rotors) or double (one Azimuth / Elevation rotor). The basic circuit provides operation with direct current motors.

Comparison

(Click to enlarge)

Download comparison table [PDF]